Bondone Bondglow

Bondone BondGlow

Bondone® BondGlow is a two components modified low viscous epoxy coating system. Excellent coating or lamination can be achieved on most of the substrates including glass, metals, plastics, wood, paper stickers and natural stones. When both components are mixed properly and cured at room temperature, an excellent high gloss coating can be achieved.

Features:

1. Excellent hardness

2. Good adhesion and flexibility

3. High gloss and clarity

4. Thermally stable and suitable to perform in extreme conditions

5. Good water and chemical resistant

Applications:

1. Buckles coating;

2. Key-chain metal gift articles

3. Coating and lamination of articles

4. PVC, Paper stickers

Specifications:

1. Mixing Ratio (R:H) Pbw - 100:50

2. Mix viscosity at 25°C mPas - 400-600

3. Pot life 100 gm at 25ºC Minutes - 18-30

4. Surface dry at 25 °C Minutes - 120-140

5. Touch dry at 25 °C Minutes - 120 - 160

6. Hard dry at 25 °C Minutes - 180-240 0 Water Absorption % HTP-53 0.5 Max. Hardness Shore D HTP-22 70-80

Packaging Bondone® Bondglowresin is available in 1 kg bottle and 5 kg jerry can and Bondone® Bondglow hardener is available in 500 gm, 2.5 Kg bottles.

Pre-Treatment: The surface must be thoroughly degreased with a good degreasing solvent (e.g. acetone, toluene or trichloro-ethylene). Ensure all oil, dirt and grease is removed. Alcohol or paint thinner use for such purpose is restricted. The mixed mass is applied by brush, spatula or through dispensing bottle on the surface to be coated. The mix must be used within its pot life.

Curing: Once Part A and Part B is mixed, colour change occurs after a set period of time. This is a normal phenomenon and does not affect the cured product properties. Part A and B should be mixed gently otherwise bubble formation will occur. Low temperature leads to long curing schedule and hence heat curing is advisable.

Safety: Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact, it should be washed off immediately with warm water. Avoid breathing vapours, mist or gas. Please refer to the Safety Data Sheet.

Storage Conditions: Part A & B should be stored away from light & heat. Partly emptied containers should be tightly closed immediately after use to avoid exposure to light. For information on waste disposal and hazardous products of decomposition in the event of a fire, refer to the Material Safety Data Sheets (MSDS) for these particular products.

Get in touch

Send inquiry

GIVE US A CALL