Lapox UltraFix

Lapox Ultrafix is two component, multi-functional, fast setting and high strength versatile construction, epoxy adhesive system. This is used for spot bonding of large stone and tiles on vertical surfaces and has high mechanical strength as well as outstanding resistance to water and chemicals. Lapox Ultrafix resin and hardener are to be mixed thoroughly in the recommended mixing ratio to achieve optimum results.

Applications:

1. Adhesive for bedding marble

2. Granite and other stone on walls

3. Anchoring grouts for reinforcing steel

4. Bonding of fabricated components

5. Repairing material for concrete cracks

6. Spot bonding for marbles and granites on concrete surfaces

Lapox UltraFix

Lapox UltraFix - Fast setting epoxy adhesive for multiple appications.

Advantages:

1. Allows plumb level adjustments while the stone is in place

2. Fast curing (handling strength within 60 minutes to 90 minutes)

3. Faster productivity due to rapid curing

4. High bond strength on damp surfaces

5. Out-standing resistance to water and chemicals

6. Reduction in labor cost Setting of clamps

7. Drilling and cutting of stone is not required

Mix specifications:

1. Mixing ratio (resin : hardener) w/w - 100 : 50

2. Pot life (Minutes): 10 - 15

3. Peak exotherm temperature (°C) - Max 77

Processing:

Surface preparation: All substrates must be clean and dry prior to application of Lapox Ultrafix adhesive system. Clean and grind the area of stone where Lapox Ultrafix is to be used by using mechanical wheel grinder with a diamond wheel blade. Surface after treatment must be thoroughly cleaned of all laitance, loose material, oil and grease.

Application method: Stir part A (resin) and part B (hardener) thoroughly with separate stirrer to get uniform mix mass. Take part A and B in proportion of 100 : 50 (by weight) and mix thoroughly until, homogeneous paste with uniform colour is achieved, with putty knife or margin travel. Apply immediate and evenly distribute on the back of the tile and stone. Apply minimum five days, one in each corner and other in center, dap thickness must be maintain 3 mm. The mix must be used within its pot life. Curing: Curing normally takes place at room temperature within about 24 hours depending on the ambient temperature but may be accelerated by the application of heat.

Packaging:

Lapox Ultrafix is available in 1.5 kg HDPE bottles. Other packing may be considered on request.

Storage and handling:

Lapox Ultrafix should be stored in a cool and dry place, preferably in a sealed container and should not be exposed to direct sunlight. This product has a shelf life of two years, if stored in its original container between 2°C and 40°C away from humidity and excessive heat. Safety Wear personal protective equipment (PPE). Avoid contact with the eyes and skin. In case of direct contact and irritation, it should be washed off immediately with soap and warm water. Avoid breathing vapours, mist or gas. Please refer to the Safety Data Sheet (SDS) of Lapox Ultrafix for detailed safety instructions.

Spills and disposal:

In case of spills, sweep up and shovel the spilled material. Keep spilled material in suitable, closed containers for disposal. Soak up with an absorbent such as clay, sand or other suitable material. Flush area with water to remove trace residue. Do not allow the product to reach the sewage system. Waste must be disposed of in accordance with federal, state or local regulations, as applicable.